Rane RAD16z Remote Audio Device - Mint, Open Box


  • Our Price
  • Regular price $261.95





*IN STOCK - READY TO SHIP


Take Your Signal Wherever You Need It With The Rane RAD16z Remote Audio Device

A RAD16z is an alternative to standard switchboxes for impractical areas such as in stage floor pockets or above ceilings. Its form factor is a rugged metal box with flexible surface mounting options. The RAD16z is plenum-rated UL 2043. It contains two balanced Mic/Line/Line-Plus inputs and two balanced line outputs on Euroblock connectors.

Line-Plus allows a stereo unbalanced source to connect to a single balanced input and be mono'ed. Inputs are individually software switchable to Mic, Line or Line-Plus. 24V phantom power can be enabled in software for a condenser mic on either input. LEDs indicate input mode, Input and Output level, as well as RAD connectivity to the HAL.

Two Logic Inputs and Outputs interface other devices to HAL with toggles or commands, like push-to-talk or mute switches, projectors, lights, alarms, etc. Logic In connects a device contact switch between pin 1 or 2 to ground. Logic Out is 5 V high or 0 V low. Galvanic isolation prevents current flow between the RAD and host technical grounds from interfering with audio. The RAD16z is only available in black. Mountable to any flat surface.


Microphone Inputs

  • Impedance 2.16 k ohms, limit 1%, balanced, 1.08 k + 1.08
  • Gain Range (dynamic): +26 to +46 dB, limit typical, 1 dB steps
  • Gain Range (condenser): +14 to +34 dB, limit typical, 1 dB steps
  • Maximum Input (dynamic): -16 dBu, limit minimum, balanced, gain = 26 dB
  • Maximum Input (condenser): -4 dBu, limit minimum, balanced, gain = 14 dB
  • Equivalent Input Noise: -121 dBu, limit typical, 20 kHz BW, RS = 150 ohms, 26 dB gain
  • CMRR: -70 dB, limit typical, RS = 150 ohms, 1 kHz, 26 dB gain
  • Frequency Response: 20 Hz to 20 kHz, limit typical, +0.0/-0.5 dB, at all gain settings
  • THD+N: 0.010% limit typical, at 1 kHz, 20 kHz BW, Rs = 150 ohms, -6 dBFS output, 26 dB gain
  • Phantom Power: +24 V, limit 2%, 10 mA maximum

Line/Line-Plus Inputs

  • Impedance 10 k, limit 1%, balanced
  • Gain Range 0-20 dB, limit typical
  • Maximum Input (Line Mode): 14 dBu, limit minimum, less than 1% THD
  • Maximum Input (Line-Plus Mode): 14 dBu, limit typical, at 1 kHz, active, left [+] and right [-] signals summed to mono
  • Dynamic Range: 103 dB, limit typical, 0 dBFS, 20 kHz BW, A-weighted, unity gain
  • CMRR: -50 dB, limit typical, Rs = 150 ohms, 1 kHz
  • Frequency Response: 20 Hz - 20 kHz, limit typical, +0.0/-0.5 dB

Outputs

  • Connectors: 1 Euroblock, 6 pins, 3.81 mm pitch, orange
  • Impedance 200 ohms, limit 1%, each leg
  • Maximum Output: 14 dBu, limit minimum, less than 1% THD, 10 kiloohm load
  • Dynamic Range: 106 dB Typical, 0 dBFS, 20 kHz BW, A-weighted
  • Frequency Response: 20 Hz - 20 kHz, limit typical, +0.0/-0.5 dB
  • THD+N: 0.008%, limit typical, at 1 kHz, 20 kHz BW, -6 dBFS output, RAD16z Input to Output

Indicators

  • Signal -50 dBFS Unbalanced/balanced output, green LED, peak-reading
  • Overload -0.5 dBFS Unbalanced/balanced output, red LED, peak-reading

RAD Port

  • Connectors: 1 RJ-45
  • Cable Length 500 ft. / 152 m Shielded Cat 5e cable or better; must be shielded

Logic Inputs

  • Connectors: 1 (shared) Euroblock, 6 pins, 3.81 mm pitch, black, contact closure to ground
  • Internal Pull-Up 51.1 kiloohms, 5.0 V Protected to +24 V
  • High-Input Level: Greater than 2.0 V Minimum, normal state
  • Low-Input Level: Less than 0.9 V Maximum, external circuit must sink greater than 80 microamperes to assert

Logic Outputs

  • Connectors: 1 (shared) Euroblock, 6 pins, 3.81 mm pitch, black, relay drive, LED or Logic
  • Level output
  • Internal Pull-Up 1.0 kiloohm, 5.0 V Protected to +30 V, reverse-polarity-protected
  • Sink Current 200 mA Maximum, output FET on

Dimensions (W x D x H)

  • 4.92" x 3.31" x 1.05" (12.5 x 8.4 x 2.7 cm)

Manufacturer: Rane
Model: RAD16Z
Warranty: See manufacturer website for details
SKU: I438757-GA01-3
UPC: 694318023068